Doll Skull Earrings

Instructions

1. Slide an eye pin up through an orange skull bead and form a loop to make a bead link.
2. Attach the loop on the top of the skull bead link to the bottom loop of an ear wire.
3. Attach an 8mm gold jump ring to the bottom loop of the skull bead link.
4. Cut twenty 8" lengths of orange/green multi cord. Join these together and bring the middle of the joined cords through the 8mm jump ring, so the cords are folded in half. Join the folded cords together under the jump ring.
5. Cut a 12" length of green cord. Approximately 3/4" under the 8mm jump ring, tie this green cord, around the joined cords, into a slip knot. Trim green cord tails.
6. Cut two 1 1/4" lengths of gold chain.
7. Use 4mm jump rings to attach one end of a chain to each side of the 8mm jump ring.
8. Use a 6mm jump ring to join the other end of the two chains together.
9. Trim orange/green multi cord ends to desired length.
10. Repeat steps 1-9 for the matching earring.