1. Determine desired length of beaded mask holder. (Our length was 23 ¾”.) Cut a length of beading wire 6”-8” longer than desired length.
2. Slide a closed jump ring onto a lanyard clip. Use crimping pliers and a crimp tube to connect one end of the beading wire to that jump ring. Trim wire tail.
3. Decide on desired beading pattern. You can follow the bead pattern as beads are strung onto the package strand, or rearrange beads into your own pattern. (You can experiment w/ different patterns on the flocked bead board palette.) String the desired bead pattern onto the beading wire until you reach the desired length.
4. Slide a closed jump ring onto another lanyard clip. Use crimping pliers and a crimp tube to connect the end of the beading wire to that jump ring being sure the beads will drape. Trim wire tail.